Hifonics TPS-A350.4 350w 4-Ch Amplifier+(4) 6.5 JVC Speakers 4 RZR/ATV/UTV/Cart

Features:

Hifonics TPS-A350.4 350w 4-Channel Marine Amplifier For Polaris RZR/ATV/UTV/Cart
Marine Grade Protection: YES – Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
Pre-Amp Circuitry: Low Noise Pre-Amplifier Stage – Special preamplifier reduces incoming noise from source units dramatically improving sound quality
Inputs: 2 Pair. RCA Nickel-Plated – High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
Operation Mode: Four channel operation – Flexible installation allows this amplifier to run in four channel or bridged mono mode.
Crossover / Signal Shaping: Switched FULL / LPF / HPF – Complete control of amplifier signal. essential when using two or more amplifiers
Class / Topology: Full Range Class D – Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
Output Devices Technology: PWM MOSFET Power Supply – Stable power through the PC board with minimal heat generation
Heat Sink: Aluminum – Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration
Power Supply: Simpatico Coil Design – The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
Output Connections: Quick Dissconect Wires. RCA Connections – Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
Connections Type: Gold-plated connections – Gold-plated power. ground. speaker and RCA corrosion resistant connections
Diagnostics: Three-stage protection circuits – Monitor thermal. overload. DC. and speaker short protection with lighted indicators on the amplifier end panel
Marinized / Waterproof: YES – Water resistant for durability in any environment

Specifications:

Class: Full Range Class D
Variable Voltage: 0.2V~9V
Signal to Noise Ratio: >90dB
Frequency Response: 20Hz-20kHz
Crossover Frequency Range CH1 & CH2: Switched HP/ Full
Crossover Frequency Range CH3 & CH4: Switched HP/ Full
Bass Boost: 0-12dB@45Hz
Power @ 2-Ohms: 4 x 80W
Power @ 4-Ohms: 4 x 40W
Total Channels: 4
Audio Inputs: RCA
Power Terminal 12v/GND: Molex 10 ga
Speaker Terminal Wire Gauge: Molex Plug Connector
Fusing: 1 x 30 Amps
Certifications: Marine & Powersports
Dimensions: 3.70 X 5.51 X 1.77 inches (9.4 X 14.0 X 4.5 cm)
Weight: 2.16 lbs (0.98 kg)

Features of CS-DR6200M:

Pair JVC CS-DR6200M 6.5 300w 2-Way Marine ATV Powersports Motorcycle Speakers
2-Way Coaxial Speakers
Water Resistant Woofers
UV Resistant Grilles
No thin bar gives it the Open-Minded Sound

Specifications:

Frequency Response: 60 – 18.400Hz
Power Handling Capacity (RMS): 50W
Power Handling Capacity (Peak Power): 150W
Impedance: 4 ohms
Sound Pressure Level: 87dB<

• Package Includes: (1) Hifonics TPS-A350.4 350w 4-Channel Marine Amplifier For Polaris RZR/ATV/UTV/Cart. (2) Pairs of JVC CS-DR6200M 6.5 600w 2-Way Motorcycle ATV Powersports Marine Speakers. Features: Hifonics TPS-A350.4 350w 4-Channel Marine Amplifier For Polaris RZR/ATV/UTV/Cart. Marine Grade Protection: YES – Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
• Pre-Amp Circuitry: Low Noise Pre-Amplifier Stage – Special preamplifier reduces incoming noise from source units dramatically improving sound quality. Inputs: 2 Pair. RCA Nickel-Plated – High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant. Operation Mode: Four channel operation – Flexible installation allows this amplifier to run in four channel or bridged mono mode.
• Crossover / Signal Shaping: Switched FULL / LPF / HPF – Complete control of amplifier signal. essential when using two or more amplifiers. Class / Topology: Full Range Class D – Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.. Output Devices Technology: PWM MOSFET Power Supply – Stable power through the PC board with minimal heat generation
• Heat Sink: Aluminum – Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration. Power Supply: Simpatico Coil Design – The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices. Output Connections: Quick Dissconect Wires. RCA Connections – Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
• Connections Type: Gold-plated connections – Gold-plated power. ground. speaker and RCA corrosion resistant connections. Diagnostics: Three-stage protection circuits – Monitor thermal. overload. DC. and speaker short protection with lighted indicators on the amplifier end panel. Marinized / Waterproof: YES – Water resistant for durability in any environment. Specifications: Class: Full Range Class D. Variable Voltage: 0.2V~9V. Signal to Noise Ratio: >90dB. Frequency Response: 20Hz-20kHz