ALLTIMES Motorcycles 12V SAE Charger Cable. Built-in 10A Fuse. for Motorcycle Battery Terminal

Specification:
Brand new
Color: black + red + blue
Input voltage: 12V-24V / ?? 4.0V
Output voltage: 12-24V
Length: about 500mm

Feature:
Built-in 10A power fuse.
Black (negative) and red (positive) with 7.5 A fuse.
Practical for batteries that are difficult to access.
Fine workmanship and good performance.
Safe to use.
Long lifetime.
Compatible with most heated suits for motorcycles or snowmobiles.

Installation instructions:
1.Disconnect the negative and positive battery cables from your battery.
2.Slide the RED ring connector on the positive pole screw of your battery and the BLACK ring connector on the negative pole terminal of the battery. Now replace the battery cables. starting with the positive pole and finally the negative. and make sure that nothing crosses the battery posts or any metal parts are grounded.
3.Now whenever you want to charge. just plug the pin and socket end of the cable into the maintainer and step back.

Delivery content:
1 x motorcycle charger cable

Note:
1. Please allow 1-3 cm errors due to manual measurement.
2. The object color shown in the photos may look slightly different on your computer monitor because the monitors are not calibrated the same1.Disconnect the negative and positive battery cables from your battery.
2.Slide the RED ring connector on the positive pole screw of your battery and the BLACK ring connector on the negative pole terminal of the battery. Now replace the battery cables. starting with the positive pole and finally the negative. and make sure that nothing crosses the battery posts or any metal parts are grounded.
3.Now whenever you want to charge. just plug the pin and socket end of the cable into the maintainer and step back.