ANCEL DS700 OBD2 Diagnostic Tools Professional Full System Bi-Directional Control AF Adjust DPF Injector TPMS Automotive Scanner

ANCEL DS700 Support 34+ Special Functions

1.Oil Reset
The lightening of the car maintenance light indicates that the vehicle needs maintenance.Reset the mileage or driving time to zero after the maintenance.so the maintenance light will go out and the system will start a new maintenance cycle.

2.DPF Regeneration
DPF Regeneration is used to clear PM(Particulate Matter)from the DPF filter through continuous combustion oxidation mode(such us high temperature heating conbustion.fuel additive or catalyst reduce PM ignition conbustion)to stabilize the filter perfornance.
DPF regeneration may be performed in the following cases:
a)The exhaust back pressure sensor is replaced.
b)The PM trap is removed or replaced
c)The fuel additive nozzle is removed or replaced
d)The cataytic oxidizer is removed or replaced.
e)The DPF regeneration MIL is on and maintenance is performed.
f)The DPF regeneration control module is replaced.

3.AFS(headlamp) Reset
The feature is used to initialize the adaptive headlamp system.According to the ambient light intensity.the adaptive headlamp system may decide whether to automatically turn on the headlamps.and timely adjust the headlamp lighting angle while monitoring the vehicle speed and body posture.

4.EGR Adaption
This function is used to learn the EGR(Exhaust Gas Recirculation)valve after it is cleaned or replaced.

5.Brake-pad Reset
If the brake pad wears the brake pad sense line.the brake pad sense line sends a signal sense line to the on-board computer to replace the brake pad.After replacing the brake pad.you must reset the brake pad.Otherwise.the car alarms.
Reset must be performed in the following cases:
a)The brake pad and brake pad wear sensor are replaced.
b)The brake pad indicator lamp is on.
c)The brake pad sensor circuit is short.which is recovered.
d)The servo motor is replaced.

6.Coolant Bleeding
Use this function to activate the electronic water pump before venting the cooling system.

7.Injector Coding
Writing injector actual code or rewrite code in the ECU to the injector code of the corresponding cylinder so as to more accurately control or correct cylinder injection quantity.After the ECU or injector is replaced.injector code of each cylinder must be confirmed or re-coded so that cylinder can better indentify injectors to accurately control fuel injection.

8.Airbag Reset
This function resets the airbag data to clear the airbag collision fault indicator.When the vehicle collides and the airbag deploys.the corresponding fault code of the colision data appears.the airbag indicator lights up.and the fault code can’t be cleared.Since the data inside the airbag computor is disposable.it is required that all new accessories must be ewplaced.but after performing this function.the data of the airbag computer can be recovered and the fault code can be cleared.the airbag light will go out.and the airbag computer can continue to use.

9.Tyre Reset
This function is used to set the size parameters of the modified or replaced tire.

10.ABS Bleeding
When the ABS contain air.the ABS bleeding function must be performed to bleed the brake system to restore ABS brake sensitivity.If the ABS computer.ABS pump.brake master cylinder.brake cylinder.brake line.or brake fluid is replaced.the ABS bleeding function must be performed.

11.Language Change
This function is used to change the system language of the vehicle central control panel.

12.Adblue Reset
After the diesel exhaust treatment fluid (car urea) is replaced or fil

And many more……