Polk Audio PAD5000.5 900w RMS 5-Channel Marine Amplifier Boat Amp PA D5000.5

Features:
Polk Audio PAD5000.5 5-Channel 900w RMS 2-Ohm Car Audio Amplifier Amp PA D5000.5
Super-Efficient Class D Design??Runs much cooler than conventional amps.
High-Speed MOSFET Switching??Power supply with outputs stable into 2 Ohm loads for full range channel speakers and 1 Ohm loads for subwoofer channel.
Protection??Thermal. DC offset. reverse DC voltage and short circuit protection.
Sub 1/Sub 2 Inputs??Line level inputs for subwoofer signal from head unit
SUB/INT Source Switch??In the INT position. the amplifier will filter the bass frequencies from the full range signal and send them to the subwoofer amplifier channel.
SUB Sonic Filter??Attenuates the frequencies below the settings on the control.
Remote Bass Level Control??Set gain to match output from head unit.
Rear Full. HPF Switch??Selects between no filtering or a high pass filter to dial in your speakers’ blending.
Channel Mode Switch (4CH/ST)??In the ST position. the amplifier sends the same signal to the front and rear channels.
Nickel-Plated Wire Terminals & RCA connectors?? Ensure maximum signal transfer.
Stainless Steel Hardware??Used throughout won’t corrode in humid environments.
Specifications:
Type: Bridgeable Class D MOSFET
Channels: 5 channel
RMS Continuous Power @ 4 Ohms: 70 W x 4; 200 W x 1
RMS Continuous Power @ 2 Ohms: 100 W x 4; 400 W x 1
RMS Continuous Power Bridged @ 4 Ohms: 200 W x 2
RMS Continuous Power 1 Ohm (Sub): 500 W x 1
Distortion at Rated Power: <0.1%
Remote Gain Control Included (sub only)
Minimum Impedance Bridged: 4 Ohms
Minimum Impedance Not Bridged: 2 Ohms
Minimum Impedance Subwoofer Channel: 1 Ohm
Signal-to-noise Ratio: 105 dB
Frequency Response: 20 Hz-20 kHz
Crossover Filter Slope: 12 dB/octave
Front Gain Control: 200 mV – 6 V
Filter Switch (Front): 3-position (BPF. Full. HPF)
High Pass Filter Frequency Range (Front): 40 Hz – 400 Hz
Low Pass Filter Frequency Range (Front): 80 Hz – 4 kHz
Filter Switch (Rear): 2-position (Full. HPF)
High Pass Filter Frequency Range (Rear): 40 Hz – 4000 Hz
Rear Gain Control: 200 mV – 6 V
Line Level Inputs
LED Power Indicator
LED Protection Indicator
Supply Voltage: 10 V – 16 V
Fusing & Power/Type: (2) 40 Amp ATC
Power Connections: 4 AWG
Ground Connections: 4 AWG
Speaker Connections: 12 AWG
Height: 1 13/16 (46 mm)
Depth: 6 3/4 (171.5 mm)
Width: 13 5/16 (338.1 mm)
Width w/ Terminal Adaptor: 14 1/16 (357.9 mm)
Weight: 6 3/4 lbs (3.06 kg)

• Features: Polk Audio PAD5000.5 5-Channel 900w RMS 2-Ohm Car Audio Amplifier Amp PA D5000.5. Super-Efficient Class D DesignRuns much cooler than conventional amps. High-Speed MOSFET SwitchingPower supply with outputs stable into 2 Ohm loads for full range channel speakers and 1 Ohm loads for subwoofer channel.. ProtectionThermal. DC offset. reverse DC voltage and short circuit protection.. Sub 1/Sub 2 InputsLine level inputs for subwoofer signal from head unit
• SUB/INT Source SwitchIn the INT position. the amplifier will filter the bass frequencies from the full range signal and send them to the subwoofer amplifier channel.. SUB Sonic FilterAttenuates the frequencies below the settings on the control.. Remote Bass Level ControlSet gain to match output from head unit.. Rear Full. HPF SwitchSelects between no filtering or a high pass filter to dial in your speakers blending.
• Channel Mode Switch (4CH/ST)In the ST position. the amplifier sends the same signal to the front and rear channels.. Nickel-Plated Wire Terminals & RCA connectors Ensure maximum signal transfer.. Stainless Steel HardwareUsed throughout wont corrode in humid environments.. Specifications: Type: Bridgeable Class D MOSFET. Channels: 5 channel. RMS Continuous Power @ 4 Ohms: 70 W x 4; 200 W x 1. RMS Continuous Power @ 2 Ohms: 100 W x 4; 400 W x 1
• RMS Continuous Power Bridged @ 4 Ohms: 200 W x 2. RMS Continuous Power 1 Ohm (Sub): 500 W x 1. Distortion at Rated Power: <0.1%. Remote Gain Control Included (sub only). Minimum Impedance Bridged: 4 Ohms. Minimum Impedance Not Bridged: 2 Ohms. Minimum Impedance Subwoofer Channel: 1 Ohm. Signal-to-noise Ratio: 105 dB. Frequency Response: 20 Hz-20 kHz. Crossover Filter Slope: 12 dB/octave. Front Gain Control: 200 mV – 6 V. Filter Switch (Front): 3-position (BPF. Full. HPF)
• High Pass Filter Frequency Range (Front): 40 Hz – 400 Hz. Low Pass Filter Frequency Range (Front): 80 Hz – 4 kHz. Filter Switch (Rear): 2-position (Full. HPF). High Pass Filter Frequency Range (Rear): 40 Hz – 4000 Hz. Rear Gain Control: 200 mV – 6 V. Line Level Inputs. LED Power Indicator. LED Protection Indicator. Supply Voltage: 10 V – 16 V. Fusing & Power/Type: (2) 40 Amp ATC. Power Connections: 4 AWG. Ground Connections: 4 AWG. Speaker Connections: 12 AWG. Height: 1 13/16 (46 mm)