Trickle Battery Charger 12V 1500mA Automatic Battery Charger Maintainer for Car Motorcycle Truck Lawn Mower Boat Marine SLA AGM GEL CELL WET Lead Acid Batteries

Brief: This device is 4 stages smart battery charger by

Microprocessor controlled with switch mode for 6V and 12V is selectable output .it is ideal for charging your CAR.MOTORCYCLE AND RIDE-ON TOY batteries.suit for type of batteries included AGM GEL VRLA SLA WET and deep-cycle.

 4-stage charging process:

Stage 1:
initialization.when the charger power on then it start self-check and detect the battery correct connect. low output voltage without battery Fault LED is light. please CHECK THE POLARITY IS CORRECT.

Stage 2:
Bulk charge.using the charger highest rated current for the type of battery in use until it reaches 80% capacity( LEDs 50% blinking .100% OFF)

Stage 3:
Absorption.the output voltage is limited to 7.3V(6V battery) or 14.5V(12V battery) while current declines as the battery charges to its full capacity without overheating( LEDs 50% ON .100% blinking)

Stage 4:
Float.At this stage.the battery is fully charged and the charger maintains the battery through pulse charging( LEDs 50% ON .100% ON)

IMPORTANT WARNING:
Before charging.make sure the correct battery voltage with the device voltage as same.

SPECIFICATION:
Input: 100-240VAC@50/60Hz 0.5rms
Output: DC 6.9V@ 1.5Amp
DC [email protected]
Limited voltage: 7.2~7.3V or 14.5~14.7V
Float current: 300mA~400mA
Charging mode: Fully automatic
Suitable battery: 6V or 12V AGM GEL VRLA SLA WET
Charging Battery : 6-12Ah
Maintaining Battery: 4-36Ah
Charger Size: 85X53X39mm
Safety: EN60950-1 EN60335
EMC: EN55022
Approved: CE RoHS

You’ll Receive:
Battery Charger x1
DC Output Cable with Clamp Connectors x1
DC Output Cable with Ring Connectors x1
User Manual x1

• 1. Safety reliability. the product is fully produced in accordance with the standard design of UL / CE / CCC safety certification.
• 2. Ultra low standby power consumption. in line with the five-level energy conservation standards.
• 3. Strong anti-interference. all of the products have built-in anti-electromagnetic interference filters.
• 4. The input voltage range is wide. all of which is 100-240V. which meets the global standards.
• 5. Good insulation performance. 100% of high-frequency transformers is made of safety requirements.

• 6. Full load high temperature burner. 100% aging test.
•  7. With short circuit. overload. overvoltage protection (automatic recovery) and battery anti-reverse protection.

•  8. All materials are not included in (and non-departure. restricted scope) European restricted / disabled cadmium. chromium. lead. mercury. PBB. and PBDE six toxic substances.